Belts
Belt is a looped strip of flexible material, used to
mechanically link two or more rotating shafts. They may be used as a
source of motion, to efficiently transmit power, or to track relative movement. Belts are looped over pulleys.
In a two pulley system, the belt can either drive the pulleys in the
same direction, or the belt may be crossed, so that the direction of
the shafts is opposite. As a source of motion, a conveyor belt is one application where the belt is adapted to continually carry a load between two points.
Belts are the cheapest utility for power transmission between shafts
that may not be axially aligned. Power transmission is achieved by
specially designed belts and pulleys. The demands on a belt drive
transmission system are large and this has led to many variations on
the theme. They run smoothly and with little noise, and cushion motor
and bearings against load changes, albeit with less strength than gears
or chains. However, improvements in belt engineering allow use of belts
in systems that only formerly allowed chains or gears.
Classic (wedge rope) V-belts
For the rigorous operations
Properties:
* Reliable tightening capacity
* Suitable for level V-belts for motor units
* Special types for:
-specific actions
-mining industry
-high shoulder power
Application:
* Construction machines
* Mining industry
* Driving speed control
* Transfer technology
* Transmission
* Agricultural machinery
Narrow V-belts SPZ - SPA - SPB - SPC
It is used for safe and reliable power transmission
Properties:
* Good power transfer
* Easy installation
* Special types for:
-specific actions
-mining industry
-high shoulder power
Application:
* Construction machines
* Mining industry
* Wood processing machinery
* Transfer technology
* Transmission
* Agricultural machinery
Timing belts HTD 3M - 5M - 8M - 14M
The term "timing belt" is usually used for the general case of any flat belt with integral "teeth". Such belts are used for power transmission or to interchange rotary motion and linear motion, where either high loads or maintaining a specific drive ratio are important.
Properties:
* No maintenance
* Electric-resistant(antistatic) per ISO 9563
* Moderate resistance to oil
* Ozone resistant
* Suitable for the tropical climate
* Optimal power transfer
* Very durable "teeth"
* Precisely designed teeth
* Required stability
* Minimum requirements
* Suitable for movable pulleys
Application:
* Office equipment
* Printing machines
* Vehicles
* Wood processing machinery
* Electric devices
* Robots
CONTI SYNCHROBELT MXL - XL - L - H - XH - XXH
Properties:
* No maintenance
* Electric-resistant(antistatic) per ISO 9563
* Moderate resistance to oil
* Ozone resistant
* Suitable for the tropical climate
* Can work under high dynamic pressure
* Very durable "teeth"
* Precisely designed teeth
* Required stability
Application:
* Office machines
* Vehicles
* Electrical devices
* Small use in households
* Robots
Multi rib belts - POLY V - PJ - PK - PL - PM
Applies whenever a high transfer coefficient is needed
Properties :
* Very flexible
* High bending capacity at high frequencies
* Equal distribution of power across the entire belt width
* Suitable for flat transportation units
* High durability
Application:
* Office equipment
* Printing machines
* Electric devices
* Vehicles
* Machiney equipment
Variator belts Varidur - Agridur
Used when high power transfer should be combined with the speed control.
Properties:
* No maintenance
* Reliable capacity of stretching
* Precise execution
* Special AGRIDUR types for agricultural machinery
Application:
* Speed control of the run
* Printing machines
* Vehicles
* Agricultural machinery
* Textile machinery
* Machinery equipment
